AU-ZBG10002 encoders with the
length sensor conversion kits are used for precise speed control in Omega's manufacturing process for metal sheath thermocouple wire.
The ZB Series shaft encoders are general
duty industrial rotary pulse generators. The
AU-ZBG models are for single channel sensing
for counting, one directional measuring or
speed applications. The AU-ZBH models
are for quadrature applications, allowing for
counting up and down along with speed and
direction measurements. A conversion bracket
is available to easily convert this encoder
into a length measuring sensor. They can be
direct-coupled to a machine shaft by means
of a flexible-bellows, spring, or rubber sleeve
type coupling that allows for axial and radial
misalignment. They can also be coupled with
light instrument timing-belts. Timing-belt
drives also allow convenient gear-up or geardown
speed ratio changes that can be useful
for obtaining non-standard PPR rates.
Specifications Supply Voltage: 4.75 to 28 Vdc Output: Current sinking, 250 mA maximum current per output Maximum Frequency: 1000 ppr, 20 KHz Connections: 6-pin MS style connector (male) (MIL-C-5015)
See SPECS above for full specifications and additional
information on length sensor conversion kit.
† All amounts shown in USD Note: Note: NPN Transistor outputs have 1.5 KÙ load resistors returned to supply for internal feed back purposes. This does not interfere with the ability to use these outputs as conventional “Open-Collector” outputs as long as the supply voltage for the ZB is supplied by the indicator or control receiving its output signal. The ZB’s internal load resistor also allows the output to be used as a current source, however, load current must be limited to 1 mA maximum