These spring loaded fittings provide another easy way to utilize your Omega temperature sensors.
Do you need to install a 1/4" diameter sensor in a thermowell without the use of a connection head? Install the 1/4-SLK
spring loaded fitting onto your sensor to insure proper contact with the bottom of your thermowell without worrying if your sensor is
over inserted or under inserted into the thermowell bore.
If you need to install your sensor in a thermowell while also using an enclosure for your wire connections, the SLF-12-12-14
spring loaded fitting can be used along with one of our extensive line of sanitary
or industrial connection heads.
Did you have a sudden failure and need to replace your thermowell mounted RTD or thermocouple? If you have one of our
cuttable RTD Sensors or Thermocouple sensors, just cut the sensor to length, add a spring loaded fitting and you are up and running.
Installation is simple with no tools required, simply do the following:
To install the single sided ¼-SLK fitting, slide the hex housing onto your probe with the 1/2 NPT
threads pointed toward your thermowell or other suitable attachment point. Slide the self-gripping spring onto
your probe with the wide end toward the hex housing and slide into place. The position of the
assembly can then be adjusted as needed.
For the SLF12-12-14, slide the probe tip into the larger opening
end of the fitting, twist the probe clockwise while pushing the probe through the fitting. Install
the probe to the desired length, if needed the probe can be pulled through to re-adjust the
position of the fitting.
Materials: 300 Series Stainless Steel.
Mounting Threads: The 1/4-SLK has a 1/2NPT threaded connection one end, the SLF-12-12-14 has a 1/2NPT
threaded connection both ends.
Sheath Size: The springs used in these fittings are a self gripping design for use on standard 1/4" sheaths.
Spring Compression: These springs are designed for a nominal compression of approximately 1/2".
Spring material: 0.035" diameter music wire (ASTM A228)
† All amounts shown in USD Note: Comes complete with installation instructions. Ordering Example: (1) 1/4-SLK Spring loading fitting for 1/4'' probes without connection heads, USD26.00 plus (1) SLF-12-12-14 Spring loading fitting for 1/4'' probes with connection head or enclosure, USD24.75, USD26.00 + 24.75 = USD50.75